Hi, I have a Juniper Firewall NS5GT-ADSL device in place on a WAN VPN. Clients access the VPN through the Juniper Firewall. Most of the remote clients work fine, but with two of the clients, I have the problem of the Network Connect Client Side Application not wanting to eliminarlasvarices.onlines: Apr 25, · If the PULSE SECURE NETWORK CONNECT SERVICE will not start on your PC, you may have to perform a manual uninstall of your Pulse / Juniper software. I have personally seen this problem on both Windows 7 Enterprise and Windows 10 Pro. After many hours working with Pulse support, ended up building on their limited cookbook and have detailed the instructions below. If you disable the "Enable web installation and automatic upgrade of Pulse Secure clients" option in your PCS / PPS appliance, then you will not observe the above message. This message will not be observed when you use the standalone application installer to install, launch, or upgrade to Pulse Client version(s) R15+, R8+, and above. - The download of "juniper setup client installer" happens and I execute it. After a couple of seconds it's finished, with a windows showing "Complete", but it doesn't look like it did anything. The page where I am also seems to expect that "Host Checker" is installed (looking at the text) but nothing is eliminarlasvarices.onlines: 2. Oct 27, · This message will not be observed when you use the standalone application installer to install, launch, or upgrade to Pulse Client version(s) R1+, and above. The "Enable web installation and automatic upgrade of Pulse Secure clients" setting can be found in the Administrator Console under Maintenance > System > Options.